About Us Development Scientific-researches Technology Certificates Partners Order form Contacts
BIOMASS
MANUFACTURE OF FUEL BRIQUETTES AND PELLETS



TECHNOLOGIES WITH APPLICATION OF SECONDARY MATERIALS
WOOD
MANUFACTURE OF WOOD CHIPBOARDS
MANUFACTURE OF FINISHING SLABS FROM WOODEN MATERIAL
STONES
MANUFACTURE OF FACING SLABS, BRICKS AND TILES
MANUFACTURE OF PARTITION BLOCKS
COAL
MANUFACTURE OF FUEL BRIQUETTES FROM COAL
METALS
MANUFACTURE OF BRIQUETTES FROM SECONDARY METAL REJECTS

MANUFACTURE OF WOOD CHIPBOARDS

Wood chipboards on the basis of waste wood with polymeric material Naralex LN are offered.
The material received with the use of offered technology possesses by the new following characteristics:

  • Manufacturability to processing
  • Heightened strength
  • Water resistance
  • Ecological compatibility
The receiving technology is simple. It essentially differs from known classical technologies in simplicity of receiving. The technology allows to form simultaneously both press-material and its laminate.

Veneer, plasticate, paper and other materials serve as a laminate.

The equipment represents one or multi-section presses with the heated bases (sections), between which the forms with a primary material are placed.

Technological conditions of material forming at pressing equal to 30kg/cm2, are as following: temperature is 180C, holding time is 30 minutes. The density of material received as a result of forming is 0,94 - 1,04 g/cm3. Productivity is from 10 m2/hour up to 100 m2/hour.

 

The opportunity of ordering of any products presented on a site and also of consultation, research or lecture will be given. >>more>>>
  • Briquette manufacture machine >>more>>>
  • Pellet manufacture machine >>more>>>
    Porto Sant Elpidio(AP), Via Ancona 25
    tel:
    cell:
    (39) 0734991939
    (39) 3334751759
    (39) 3403792082
    E-mail: surentechnology@libero.it
    This web page has been
    prepared with support
    of SMEDNC.
    Copyright 2005 www.SURENTECHNOLOGY.com | All rights reserved.